Med according to manufactory instruction, but with an extended synthesis at

November 14, 2017

Med according to manufactory instruction, but with an extended synthesis at 42 C for 120 min. Subsequently, the cDNA was added 50 l DEPC-water and cDNA concentration was measured by absorbance readings at 260, 280 and 230 nm (NanoDropTM1000 Spectrophotometer; Thermo Scientific, CA, USA). 369158 qPCR Each cDNA (50?00 ng) was used in triplicates as template for in a reaction volume of 8 l containing 3.33 l Fast Start Essential DNA Green Master (2? (Roche Diagnostics, Hvidovre, Denmark), 0.33 l primer premix (containing 10 pmol of each primer), and PCR grade water to a total volume of 8 l. The qPCR was performed in a Light Enzastaurin chemical information Cycler LC480 (Roche Diagnostics, Hvidovre, Denmark): 1 cycle at 95 C/5 min followed by 45 cycles at 95 C/10 s, 59?64 C (primer dependent)/10 s, 72 C/10 s. Primers used for qPCR are listed in Supplementary Table S9. Threshold values were determined by the Light Cycler software (LCS1.5.1.62 SP1) using Absolute Quantification Analysis/2nd derivative maximum. Each qPCR assay included; a standard curve of nine serial dilution (2-fold) points of a cDNA mix of all the samples (250 to 0.97 ng), and a no-template control. PCR ENMD-2076 site efficiency ( = 10(-1/slope) – 1) were 70 and r2 = 0.96 or higher. The specificity of each amplification was analyzed by melting curve analysis. Quantification cycle (Cq) was determined for each sample and the comparative method was used to detect relative gene expression ratio (2-Cq ) normalized to the reference gene Vps29 in spinal cord, brain, and liver samples, and E430025E21Rik in the muscle samples. In HeLA samples, TBP was used as reference. Reference genes were chosen based on their observed stability across conditions. Significance was ascertained by the two-tailed Student’s t-test. Bioinformatics analysis Each sample was aligned using STAR (51) with the following additional parameters: ` utSAMstrandField intronMotif utFilterType BySJout’. The gender of each sample was confirmed through Y chromosome coverage and RTPCR of Y-chromosome-specific genes (data dar.12324 not shown). Gene-expression analysis. HTSeq (52) was used to obtain gene-counts using the Ensembl v.67 (53) annotation as reference. The Ensembl annotation had prior to this been restricted to genes annotated as protein-coding. Gene counts were subsequently used as input for analysis with DESeq2 (54,55) using R (56). Prior to analysis, genes with fewer than four samples containing at least one read were discarded. Samples were additionally normalized in a gene-wise manner using conditional quantile normalization (57) prior to analysis with DESeq2. Gene expression was modeled with a generalized linear model (GLM) (58) of the form: expression gender + condition. Genes with adjusted P-values <0.1 were considered significant, equivalent to a false discovery rate (FDR) of 10 . Differential splicing analysis. Exon-centric differential splicing analysis was performed using DEXSeq (59) with RefSeq (60) annotations downloaded from UCSC, Ensembl v.67 (53) annotations downloaded from Ensembl, and de novo transcript models produced by Cufflinks (61) using the RABT approach (62) and the Ensembl v.67 annotation. We excluded the results of the analysis of endogenous Smn, as the SMA mice only express the human SMN2 transgene correctly, but not the murine Smn gene, which has been disrupted. Ensembl annotations were restricted to genes determined to be protein-coding. To focus the analysis on changes in splicing, we removed significant exonic regions that represented star.Med according to manufactory instruction, but with an extended synthesis at 42 C for 120 min. Subsequently, the cDNA was added 50 l DEPC-water and cDNA concentration was measured by absorbance readings at 260, 280 and 230 nm (NanoDropTM1000 Spectrophotometer; Thermo Scientific, CA, USA). 369158 qPCR Each cDNA (50?00 ng) was used in triplicates as template for in a reaction volume of 8 l containing 3.33 l Fast Start Essential DNA Green Master (2? (Roche Diagnostics, Hvidovre, Denmark), 0.33 l primer premix (containing 10 pmol of each primer), and PCR grade water to a total volume of 8 l. The qPCR was performed in a Light Cycler LC480 (Roche Diagnostics, Hvidovre, Denmark): 1 cycle at 95 C/5 min followed by 45 cycles at 95 C/10 s, 59?64 C (primer dependent)/10 s, 72 C/10 s. Primers used for qPCR are listed in Supplementary Table S9. Threshold values were determined by the Light Cycler software (LCS1.5.1.62 SP1) using Absolute Quantification Analysis/2nd derivative maximum. Each qPCR assay included; a standard curve of nine serial dilution (2-fold) points of a cDNA mix of all the samples (250 to 0.97 ng), and a no-template control. PCR efficiency ( = 10(-1/slope) – 1) were 70 and r2 = 0.96 or higher. The specificity of each amplification was analyzed by melting curve analysis. Quantification cycle (Cq) was determined for each sample and the comparative method was used to detect relative gene expression ratio (2-Cq ) normalized to the reference gene Vps29 in spinal cord, brain, and liver samples, and E430025E21Rik in the muscle samples. In HeLA samples, TBP was used as reference. Reference genes were chosen based on their observed stability across conditions. Significance was ascertained by the two-tailed Student’s t-test. Bioinformatics analysis Each sample was aligned using STAR (51) with the following additional parameters: ` utSAMstrandField intronMotif utFilterType BySJout’. The gender of each sample was confirmed through Y chromosome coverage and RTPCR of Y-chromosome-specific genes (data dar.12324 not shown). Gene-expression analysis. HTSeq (52) was used to obtain gene-counts using the Ensembl v.67 (53) annotation as reference. The Ensembl annotation had prior to this been restricted to genes annotated as protein-coding. Gene counts were subsequently used as input for analysis with DESeq2 (54,55) using R (56). Prior to analysis, genes with fewer than four samples containing at least one read were discarded. Samples were additionally normalized in a gene-wise manner using conditional quantile normalization (57) prior to analysis with DESeq2. Gene expression was modeled with a generalized linear model (GLM) (58) of the form: expression gender + condition. Genes with adjusted P-values <0.1 were considered significant, equivalent to a false discovery rate (FDR) of 10 . Differential splicing analysis. Exon-centric differential splicing analysis was performed using DEXSeq (59) with RefSeq (60) annotations downloaded from UCSC, Ensembl v.67 (53) annotations downloaded from Ensembl, and de novo transcript models produced by Cufflinks (61) using the RABT approach (62) and the Ensembl v.67 annotation. We excluded the results of the analysis of endogenous Smn, as the SMA mice only express the human SMN2 transgene correctly, but not the murine Smn gene, which has been disrupted. Ensembl annotations were restricted to genes determined to be protein-coding. To focus the analysis on changes in splicing, we removed significant exonic regions that represented star.